Society is advancing, technology is developing, and the screen printing industry has gradually been replaced by semi-automatic and fully automatic screen printing machines from the original manual. Zhejiang Licheng Printing and Dyeing Equipment Co., Ltd. has been focusing on the RD and production of screen printing machinery and Hot Air Stenter for more than 10 years. The screen printing machine of Licheng printing and dyeing equipment is sold at home and abroad, not only because of advanced technology, the materials of the Open Type Rotary Screen Printer are also very good, the production operation process is strict and formal, and the machine undergoes multiple process quality inspections before leaving the factory to ensure Every screen printing machine that leaves the factory is qualified.
Maintenance method of open rotary screen printing machine and working environment:- The printing studio environment should be clean, especially the printing glass, must be wiped clean before work, and the developing machine should be cleaned and maintained regularly;
- The inspection of voltage and power grid should ensure that it is within the voltage used to avoid excessive voltage or low voltage;
- The storage area of the PS version should be set in an air-conditioned dark room or a place with low temperature and dry as much as possible, especially avoiding the water tank;
- Do not bend it when using the PS version. Do not touch the plate surface with the hands stained with oil or developer.
Second, the maintenance and maintenance of the air compressor components of the open rotary screen printing machine:
The open rotary screen printing machine's air compressor component can not allow too much water and oil to enter the air pressure system, to avoid cylinder failure and shorten the service life of the cylinder, to ensure that the compressed air is dry and clean, if possible, it is best to add Install a freeze dryer; check whether the oil volume in the oil cup in the converter is sufficient every day, the relief valve is not used for a long time, and should be pushed to the rear end; when the work is stopped, the main power switch and the compressed air source should be turned off; the speed control valve cylinder And the magnetic center of each part should avoid magnetic loss; the horizontal slide seat part of the table and the precision highly coordinated components must be cleaned and oiled frequently to prevent the precision from being affected by rust.
