The Hot Air Stenter Machine static eliminator can also be called a static elimination device. It uses high-voltage current (AC) to ionize the surrounding air through the discharge of the static elimination rod, and the product static electricity carried by the static elimination rod is eliminated in time. The Hot Air Stenter Machine static eliminator adopts a high-efficiency transformer in a high-grade insulated metal box, and also has cutting-edge discharge and technology. The corona discharge method does not have any consumption and can guarantee permanent use. It can achieve the effect of almost completely eliminating static electricity. There will be no risk of electric shock when touching anything. When eliminating static electricity, it is not necessary to touch the static electricity to avoid damage to the product. Hot Air Stenter Machine's static eliminator can be 110V, 220V or 380V depending on the power supply voltage of the region. One host can supply multiple static elimination rods.

    Although the assembly of the static eliminator device is simple, the high-voltage output and the static rod needle should be carefully paid attention to the safety and use effect and play when assembling.

1. The amount of high voltage wires should be as short as possible, because too long wires will increase the electrostatic capacity or consume the effect of static electricity.
2. Reduce the static capacitance of the high-voltage line and try to get away from the metal wall and other objects. For example, the high-voltage line needs to be fixed by the extension wall to ensure the best isolation. Avoid wrapping with metal.
3. If you want to penetrate the skeleton iron plate, the diameter of the digging hole should be more than 8cm, and the center of the hole should be covered with a hard PVC pipe to keep the high-voltage wires in and out.
4. Places with dripping water, water vapor, flammable gases, and solvents will cause the danger of conduction and damage to insulation.
5. If the high-voltage cable of the Flat Screen Printing Machine Factory needs to be updated or lengthened, it must be a qualified flat, otherwise it will easily cause harm. There are two grounding wires (green 2mm2) attached to the static bar and the host to make sure that they are grounded. Use the body (metal) as a conductor on the body platform. If the two are very close, it is better to connect the two ground wires.