- An energy-saving clutch is installed on the main motor shaft of the Hot Air Stenter Machine. Drive the cylinder with a V-belt. When the licker roller is driven by the cylinder, the structure is simple and reliable, and the start is stable. It is equipped with a licker roller speed sensor to make the licker roller speed parallel to the switch car. Prevent traffic jams.
2. Doffer motor AC variable frequency stepless speed regulation, slow spinning, fast running, convenient operation, sensitive control, and reliable; the transmission adopts timing belt, stable operation and low noise.
3. The Hot Air Stenter Machine feed roller is driven by a separate motor. AC variable frequency stepless speed regulation and doffer joint control.
4. A three-roller stripping device is adopted, and a positively driven cleaning roller is installed above the stripping roller. To prevent the doffer clothing from being injured. A movable trough-shaped isolated plate collector is installed between the roller and the large pressure roller. To improve the stability of dynamic rotation
5. There is a fan and dust filter box on the left side of the machine. The waste flowers on the machine are continuously sucked, stored in the dust filter, and then sucked out in sequence by the dust collection system outside the machine. The waste flower and the car belly flower in the dust filter are separately sucked, which can reduce the power of each fan. It can also improve fiber utilization.
6. The unique frame is high in strength and easy to adjust. Facilitate the disassembly of the large drain bottom.
7. Adapt to cotton roll or cotton box feeding
8. Set front and rear fixed cover plates and licker-in combing plates.
9. Optimized design of cylinder structure, strengthen rigidity and improve accuracy.
10. Convenient and safe fully enclosed enclosure.
11. Stop around
12. The cover of Flat Screen Printing Machine Factory adopts 0.56mm small heel toe. Improve combing performance.
Licheng Flatprinter
33 Blog Posts
